Remote sensor series

Transcriptie

1 Remote sensor series DATASHEET Sensor Partners BV James Wattlaan DP Drunen The Netherlands +1 ()1-7 9 info@sensorpartners.com sensorpartners.com Sensor Partners BVBA Z.1 Researchpark 1 B-1, Zellik Belgium + () info@sensorpartners.com sensorpartners.com

2 Description Operation mode and max sensing range: Thru-beam: Dependent on amplifier (up to 7m) Diffuse proximity: Dependent on amplifier (up to 5m) Optional sensor monitor Wide variety of housings High tolerance to hostile environments Cable or plug connections Available with optional ATE approval The remote sensor series, which consists of a transmitter LT and receiver LR, is made to operate in conjunction with a Telco photoelectric amplifier from the PA, MPA or PAB programmes. The series is available with optional power-(lr) and output-(lt) monitor s for use with any Telco photoelectric amplifier which has the sensor drive feature incorporated. The remote sensors are available in a wide range of housings, with either cable or plug connection, and may be used in thru-beam or diffuse proximity mode. Technical Data LT LR Transmitter diode Ga Al As, ( nm) Photo transistor Silicon NPN Housing material Sensor housing Refer to Available Types Front lens Cable, PVC Ø, mm x,5 mm 1 x,5 mm + shield Min. cable bending radius 5 mm Environmental Data Vibration Shock 1 55 Hz,,5 mm 11 Series > 5 lux Light incidence 1 Series > lux 11/1 Series > 1 lux Temperature, operation 5 to +5 C Temperature, storage to + C Sealing class IP 7 Approvals g a

3 Available Types Series Optical Connection 5 m cable 15 m cable pin, M plug pin, M1 plug Angle Housing Material Housing Type Order Reference Receiver Transmitter 11 +/ 1 +/ Ø1 LT 11 AP5 5 LT 11 AP5 15 LT 11 AP5 T LT 11 TP5 5 LT 11 TP5 15 LT 11 TP5 T Nickel Plated Brass M1 x 1 LT 11 TB5 5 LT 11 TB5 15 LT 11 TB5 T Stainless Steel (VA) LT 11 TS5 5 LT 11 TS5 15 LT 11 TS5 T Polyester 9,5 x 11,5 LT 11 SG 5 LT 11 SG 15 LT 11 SG T ABS Ø1,7 Snap LT 11 S 5 LT 11 S 15 Ø1 LR 11 AP5 5 LR 11 AP5 15 LR 11 AP5 T LR 11 TP5 5 LR 11 TP5 15 LR 11 TP5 T Nickel Plated Brass M1 x 1 LR 11 TB5 5 LR 11 TB5 15 LR 11 TB5 T Stainless Steel (VA) LR 11 TS5 5 LR 11 TS5 15 LR 11 TS5 T Polyester 9,5 x 11,5 LR 11 SG 5 LR 11 SG 5 LR 11 SG T ABS Ø1,7 Snap LR 11 S 5 LR 11 S 5 Ø1 LT 1H AP 5 LT 1H AP 15 LT 1H AP T LT 1H TP 5 LT 1H TP 15 LT 1H TP T +/ 1 Nickel Plated Brass M1 x 1 LT 1H TB 5 LT 1H TB 15 LT 1H TB T LT 1H TB5 J (High Power) Stainless Steel (VA) LT 1H TS 5 LT 1H TS 15 LT 1H TS T LT 1H TS5 J Receiver Transmitter 1 +/ +/ 7 Polyester 9,5 x 11,5 LT 1H SG 5 LT 1H SG 15 LT 1H SG T Ø1,7 Snap LT 1H S 5 LT 1H S 15 Ø1 LT 1 AP 5 LT 1 AP 15 LT 1 AP T LT 1 TP 5 LT 1 TP 15 LT 1 TP T Nickel Plated Brass M1 x 1 LT 1 TB 5 LT 1 TB 15 LT 1 TB T LT 1 TB5 J Stainless Steel (VA) LT 1 TS 5 LT 1 TS 15 LT 1 TS T LT 1 TS5 J Polyester 9,5 x 11,5 LT 1 SG 5 LT 1 SG 15 LT 1 SG T Ø1,7 Snap LT 1 S 5 LT 1 S 15 Ø1 LR 1 AP 5 LR 1 AP 15 LR 1 AP T LR 1 TP 5 LR 1 TP 15 LR 1 TP T Nickel Plated Brass M1 x 1 LR 1 TB 5 LR 1 TB 15 LR 1 TB T LR 1 TB5 J Stainless Steel (VA) LR 1 TS 5 LR 1 TS 15 LR 1 TS T LR 1 TS5 J Polyester 9,5 x 11,5 LR 1 SG 5 LR 1 SG 15 LR 1 SG T Ø1,7 Snap LR 1 S 5 LR 1 S 15 Receiver Transmitter 11 +/ 5 +/ Ø1 LT 11 AP 5 LT 11 AP 15 LT 11 AP T LT 11 TP 5 LT 11 TP 15 LT 11 TP T Nickel Plated Brass M1 x 1 LT 11 TB 5 LT 11 TB 15 LT 11 TB T LT 11 TB5 J Stainless Steel (VA) LT 11 TS 5 LT 11 TS 15 LT 11 TS T LT 11 TS5 J Ø1 LR 11 AP 5 LR 11 AP 15 LR 11 AP T LR 11 TP 5 LR 11 TP 15 LR 11 TP T Nickel Plated Brass M1 x 1 LR 11 TB 5 LR 11 TB 15 LR 11 TB T LR 11 TB5 J Stainless Steel (VA) LR 11 TS 5 LR 11 TS 15 LR 11 TS T LR 11 TS5 J Receiver Transmitter +/ LT 1 TB5 5 LT 1 TB Nickel Plated Brass M1 x 1 +/,5 LR 1 TB5 5 LR 1 TB5 15 Note: 1. Photo amplifiers to be ordered separately.. Remote sensors are available with optional power (LR) and output (LT) monitor s for use with the applicable Telco photoelectric amplifier, which has the sensor drive. Add L after the series number for sensor monitor e.g. LT/LR 11L AP 5 5. Sensors marked are not available with this optional feature.. Remote Sensor series with cable connection is available to comply with ATE II GD T EEx na II U. Add /E after the series number e.g. LT/LR 1/E TS 5. Sensors marked are not available to comply with ATE approval.

4 Applicable Photoelectric Amplifiers and Maximum Ranges Remote Sensor Series Diffuse Diffuse Diffuse Diffuse Thru-beam Thru-beam Thru-beam Thru-beam Amplifier Series Proximity Proximity Proximity Proximity Photoelectric Amplifier Series PA 1 m, m 1 m,7 m m 1, m 5 m,5 m PA 9 5 m, m PA 1 A 11 m,9 m B 15 m 1,1 m 5 m m m m PA 11 1 m 1,1 m m m 7 m 5 m Multiplexed Amplifier Series MPA 1 1 m,7 m 5 m 1, m 5 m,5 m MPA 1 A/B m, m 1 m 1, m 5 m m C/D m, m 9 m,7 m 1 m 1, m MPA 1 A/B m, m 1 m 1, m 5 m m C/D m, m 9 m,7 m 1 m 1, m Photoelectric Amplifier Bus Series PAB 1 1 m 1, m m m 7 m 5 m PAB 1 m, m 7 m 1,7 m 7 m, m PAB 1 m, m 7 m 1,7 m 7 m, m Note: Sensing ranges using glass fibre optics, please refer to page 19. Connections Cable M Plug / Cable M1 Plug / Cable Transmitter Signal Red Pin 1 / Brown Pin 1 / Brown Transmitter Ground Black Pin / Blue Pin / Blue Receiver Signal ellow Pin / Black Pin / Black Receiver Ground Shield Pin / Blue Pin / Blue pin, M pin, M1 Sensor Plug (Male) Cable Plug (Female) Black Sensor Plug (Male) Cable Plug (Female) Brown 1 1 Brown 1 1 White Blue Blue Black Wiring Diagrams Red 1 Signal ellow Signal Black Ground Shield Ground LT LR

5 Dimensions and Descriptions Series 11 Ø 1,5 Ø M1 x 1,5 5 1 Ø 1,5 9,5,7 1,5 9,5,7 5 AP5 5/15 TP/TB/TS5 5/ Ø 9 Ø,5 1 Ø 9 Ø,5 Ø 1 M x 1 M1 x 1 M x AP5 T TP/TB/TS5 T Ø M x 1 Ø 15,5 Ø 1,7 SG 5/15 SG T Ø S 5/15,5 Series 1 Ø 1 1,5 Ø M1 x 1 1,5 Ø 1,5 9,5,7 1,5 9,5,7 AP 5/15 TP/TB/TS 5/ Ø 9 Ø,5 1 Ø 9 Ø,5 Ø 1 M x 1 M1 x 1 M x M x 1 AP T TP/TB/TS T Ø 5 SG 5/15 SG T Ø 15,9 Ø 1,7 Ø M1 x 1 M1 x 1 S 5/15 TB/TS5 J

6 Series 11 Ø 1 1,5 Ø M1 x 1 1,5 Ø 5 M1 x 1 M1 x 1 AP 5/15 TP/TB/TS 5/15 TB/TS5 J 9 9 Ø 1 M x 1 M1 x 1 M x 1 AP T TP/TB/TS T Series M1 x 1 Ø TB5 5/15 Sensing Characteristics Parallel (Thru-beam) LT 1H LT Series 11 Series Series 11 Series 1

7 Description Operation mode and max sensing range: Thru-beam: Dependent on amplifier (up to 7m) Diffuse proximity: Dependent on amplifier (up to 5m) Optional sensor monitor Wide variety of housings High tolerance to hostile environments Cable or plug connections Available with optional ATE approval The remote sensor series, which consists of a transmitter LT and receiver LR, is made to operate in conjunction with a Telco photoelectric amplifier from the PA, MPA or PAB programmes. The series is available with optional power-(lr) and output-(lt) monitor s for use with any Telco photoelectric amplifier which has the sensor drive feature incorporated. The remote sensors are available in a wide range of housings, with either cable or plug connection, and may be used in thru-beam or diffuse proximity mode. Technical Data LT LR Transmitter diode Ga Al As, ( nm) Photo transistor Silicon NPN Housing material Sensor housing Refer to Available Types Front lens Cable, PVC Ø, mm x,5 mm 1 x,5 mm + shield Min. cable bending radius 5 mm Environmental Data Vibration Shock 1 55 Hz,,5 mm 11 Series > 5 lux Light incidence 1 Series > lux 11/1 Series > 1 lux Temperature, operation 5 to +5 C Temperature, storage to + C Sealing class IP 7 Approvals g a

8 Series 11 Ø 1 1,5 Ø M1 x 1 1,5 Ø 5 M1 x 1 M1 x 1 AP 5/15 TP/TB/TS 5/15 TB/TS5 J 9 9 Ø 1 M x 1 M1 x 1 M x 1 AP T TP/TB/TS T Series M1 x 1 Ø TB5 5/15 Sensing Characteristics Parallel (Thru-beam) LT 1H LT Series 11 Series Series 11 Series 1